Microseeding Explained

Microseeding is a method used in protein crystallography where small seed crystals can be used to induce the formation of larger crystals. Microseeding was first shown to generate untwinned crystals of a compound called LigM, an O-demethylase, using untwinned crystals as seeds.

Skip to:

Protein structure can be determined using crystallography, involving microseedingSergei Drozd | Shutterstock

Crystal twinning

Twinning occurs when two separate crystals grow symmetrically in different directions from the same crystal lattice locations, due to an interruption or change in the lattice during growth by a larger ion (kwown as growth twinning). Transformation twinning occurs during cooling, where a crystal becomes unstable and restabilizes by transforming it's structure. A final form of twinning is deformation twinning, which occurs when the crystal is placed under stress and undergoes re-organization.

Twinning is a well-recognized problem in protein crystallography, as it makes determining the crystal structure of a sample difficult.

To avoid or correct this problem, methods such as detwinning, where crystals are physically separated, have been developed. Twinning can also be prevented by optimizing the length of the protein fragment that can lead to the formation of untwinned crystals. However, this method requires a lot of time. Microseeding therefore offers a viable, low-cost alternative.

Microseeding versus macroseeding

Seeding is a powerful method for the nucleation and growth of crystals. It can be divided into two classes: macroseeding and microseeding. Macroseeding refers to the transfer of a single crystal of size 5–50 μm to initiate the process of crystallization. While in microseeding, submicroscopic seeds are used to initiate the crystallization process.

In microseeding, untwinned crystals are used as seeds and are put into droplets that are brought into a state of equilibrium at lower levels of supersaturation. This method can generate different crystal structures and is also used to improve the reproducibility of crystallization.

In a study published in 2016, the researchers used twinned crystals of LigM as the seed for the process of microseeding. After the process of optimization, untwinned crystals could be generated. Microseeding was therefore regarded as a simple method to overcome the problem of twinning in crystallography.

Microseeding protocol

Preparing the seed stock

First, crystals are washed to remove the presence of any amorphous precipitates. The remaining crystals is then stabilized by suspension in a non-dissolving precipitant solution. The entire process is carried out at a temperature at which the crystals do not dissolve. Subsequently, the crystals are crushed in a glass homogenizer and this is stored until needed. Other methods to pulverize or smash the seeds include using tissue homogenizers, sonication, vortexing, seeds beads, glass rods, etc.

Serial dilution

The seeds are then serially diluted such that a final dilution is reached ranging from 1:1000 to 1:10,000,000. The dilution is carried out using the stabilizing precipitant solution. Although making a serially diluted stock of the seed is more quantitative, but streak seeding is the easiest and fastest method for seed transfer. Streak seeding is done by simply passing a thin rod coated with seed crystals through the droplet.

Seeding process

The preequilibrated drops are streaked using seeds of different dilutions. The precipitant concentration should be reduced in case the nucleation is independent of the dilution. However, if the number of crystals decreases, this can be addressed by increasing the concentration of precipitant in the seeds.

Disadvantages of microseeding

Although crystallization is used to recover pure proteins from an impure fermentation broth, this method may not work in cases where the protein solution is not pure. The purity of protein solution is one of the critical determining factors for a successful outcome of this method.

In one study, researchers looked at the effect of protein solution contaminated with either a structurally unrelated protein or structurally similar protein. They found that any kind of contamination could hamper the seeding process.

Sources

Further Reading

Last Updated: May 1, 2019

Dr. Surat P

Written by

Dr. Surat P

Dr. Surat graduated with a Ph.D. in Cell Biology and Mechanobiology from the Tata Institute of Fundamental Research (Mumbai, India) in 2016. Prior to her Ph.D., Surat studied for a Bachelor of Science (B.Sc.) degree in Zoology, during which she was the recipient of an Indian Academy of Sciences Summer Fellowship to study the proteins involved in AIDs. She produces feature articles on a wide range of topics, such as medical ethics, data manipulation, pseudoscience and superstition, education, and human evolution. She is passionate about science communication and writes articles covering all areas of the life sciences.  

Citations

Please use one of the following formats to cite this article in your essay, paper or report:

  • APA

    P, Surat. (2019, May 01). Microseeding Explained. News-Medical. Retrieved on January 02, 2024 from https://www.news-medical.net/life-sciences/Microseeding-Explained.aspx.

  • MLA

    P, Surat. "Microseeding Explained". News-Medical. 02 January 2024. <https://www.news-medical.net/life-sciences/Microseeding-Explained.aspx>.

  • Chicago

    P, Surat. "Microseeding Explained". News-Medical. https://www.news-medical.net/life-sciences/Microseeding-Explained.aspx. (accessed January 02, 2024).

  • Harvard

    P, Surat. 2019. Microseeding Explained. News-Medical, viewed 02 January 2024, https://www.news-medical.net/life-sciences/Microseeding-Explained.aspx.

Comments

The opinions expressed here are the views of the writer and do not necessarily reflect the views and opinions of News Medical.
Post a new comment
Post